Polygonal masonry reveals its secrets …
We have already found out earlier that clearly unearthly technologies are involved in the polygonal masonry of the "gods" - in particular, with regard to softening stones and turning it into a kind of "plasticine". It can also be assumed that one of the tasks of applying the technology was the strength and stability of buildings located, as a rule, in the mountains, in the seismically active zone (where the "gods" lived). And today, despite the fact that, for example, Peru shakes every year, polygonal masonry has been preserved for many millennia, while ordinary buildings cannot withstand even decades.
Here is a living example of what happens to a building when the temple was built from bricks held together with cement, but without taking into account the seismic activity of the region.
Technologies of "divine" construction
A little about the technology of building "gods". For construction to be effective, it is necessary that the building material and the construction site itself are as close to each other as possible. For this, a limestone rock was cut and transferred to the construction site. Then the limestone was densed or recrystallized, and then the construction itself began, that is, the construction was carried out not around the rocks, but around the building material inside the construction site.
The speed of the neutron is about 100 km per second. If we assume that the time the neutron spends in the block is about 5 ms, during which the neutron will make 18000 collisions with the nuclei of the crystal lattice, then we can imagine that as soon as the neutron plasticizer is turned off, the block will immediately freeze in its state.
Promotional video:
From this it follows that the technology of masonry construction should include plasticization of at least two rows of blocks at the same time. During plasticization, two completely different processes can be distinguished. The first process involves minimizing the block's surface energy. Therefore, we have a pincushion of blocks.
The second process is gravitational sliding and extrusion of the surface layer. This gives the blocks a soft finish and the need to chamfer (remove excess extruded material). Since the plasticization was done gradually, in two rows of masonry, we have approximately the same otbolovat and cushion-shaped blocks.
The elongation of the nipples speaks of vacuum suction cups. What was the vacuum for?
Two options are seen, the first is the need for vacuum for plasticization, and the second option is a supporting device in the conditions of plasticization of the block.
"Plasticine technology" and in the conditions of modern civilization promises many advantages.
