How to get energy from what cannot be
In any category of knowledge, there are topics that they try not to raise for wide discussion, this is almost bad manners. In the field of alternative energy, such areas include everything that can be interpreted as a perpetual motion machine. Let's clarify right away - there is no perpetual motion machine!
Everything started in time, in time, will end.
In 1775, the French Academy of Sciences forbade them even to be considered. Since then, they have accumulated several dozen different devices that have been working for tens and hundreds of years without any human effort. How some of them work have been explained in recent decades. Several models have even been commercialized. For example, the Atmos clock produced in Switzerland has become the same national souvenir as the matryoshka and samovar in Russia. They do not need to be turned on, they draw energy from daily fluctuations in temperature or changes in atmospheric pressure. The very first such device has been in operation for a century and a half.
And in the Oxford Museum there is an alarm clock that has been ringing with a frequency of 2 beats per second since 1840! Nobody knows exactly how it works, because its inventor hid the device in a double glass case.
And then there's the Crookes spinner.
Promotional video:
or at least a toy "Drinking bird". In general, there are such devices!
Of course, they will not work forever, but this is not required for the autonomous power supply of a private house! Enough 20-30 years, until the parts wear out. For example, Karpen's pillar, has been producing electricity for 60 years.
It may not have been enough, but there was energy!
What magnets can do
Since ancient times, magnets have attracted the attention of restless and seeking people. But if before the 20th century, attempts to build a non-volatile motor were based on the attraction of opposite poles, then 75 years ago the paradigm changed. It may sound paradoxical, but the minds of inventors began to be attracted by the repulsion of the magnet poles of the same name.
In the mid-40s, the Englishman Searle came up with an original design that was ingeniously simple and incomprehensible to madness. Around the ring magnet, he placed small cylindrical magnets. At the same time, he selected the layout of the poles in such a way that they would repel from the central ring. This device was called the Searle disk.
After spinning up, the magnets began to auto-accelerate, the speed reached some insane values, and then the incredible happened - the disk soared into the air and disappeared. The story describes that Searle made several more similar discs, but for some reason the idea was not continued.
Roshchina-Godin converter
In the mid-90s, two Russian scientists, Vladimir Roshchin and Sergei Godin, on the basis of the Russian Academy of Sciences decided to test Searle's idea. But they approached the problem from a scientific standpoint.
All projects and test results were documented and published. To say that the result was phenomenal is to say nothing.
Description of the generator and experiment
An installation weighing 350 kilograms was assembled on the ground floor. For the manufacture of the central ring magnet (stator), 110 kg of rare earth magnets were used, and the mass of all rollers was 115 kg. The diameter of the converter is about 1 m. Mechanisms for initial unwinding, registration of mass, temperature and an original method of generating electricity were provided.
Applying voltage to the built-in motor, the rollers spun up to 200 rpm without any effects. Then there was a decrease in the mass of the device, and a decrease in power consumption for starting. At 550 rpm, the converter abruptly went into self-spinning mode, the current consumption dropped to zero, and the weight decreased by 50%.
Since the stator was assembled from several segments, the speed was forcibly limited to 10 rps. At this time, the active load was removed from the converter. For this, several heating elements were connected in series, with a capacity of 1 kW each.
After the next heating element was connected to the circuit, the rotation speed slightly decreased, but recovered very quickly. As a result, the converter was able to produce 7 kW of electricity without stopping rotation. Depending on the direction of rotation, clockwise or counterclockwise, the installation either increased the mass or decreased it. The room smelled of ozone.
There was also a strange effect - a wall of cold.
Within a radius of about 15 meters, an anomalous decrease in temperature by 7-8˚C was observed and recorded by sensors. These cold zones, like rays, diverged from the installation: a sector of low temperature 6 cm thick, then a gap of about 0.8 m, and so on in a circle. Outside the walls of the laboratory, on the street and on the second floor, temperature anomalies were felt even by the body.
Over a month of experiments, more than 5 dozen converter launches were carried out in different modes. All experimental results are recorded.
Conclusions of scientists
A quarter of a century has passed since those experiments, but both enthusiasts were unable to describe the effects of the converter in the framework of the paradigm of official science:
- The fact of receiving free energy has been recorded.
- The converter material remains intact.
- Abnormal temperature locations, some weird byproduct.
During the experiments, many laboratory workers were in the area of the alternative energy generator, where other unexplained phenomena such as the glow of objects or corona discharges of electricity were noted, but this did not affect health and well-being in any way.
Practical application of the Roshchin Godin generator
Imagine a person digs a deep dry well in his yard, installs the Roshchin Godin generator there, and only two live wires go upstairs.
Convenient scheme. It remains only to assemble a free energy generator. There are drawings, magnets can be bought.
But you will have to do it yourself, solely at your own peril and risk. For in our usual view, government bodies no longer exist. The remnants will swarm for another six months, and then follow in the wake of the first president of the USSR.
And the owners of private houses will have to think about how to get electricity from alternative sources.
History of John Searl's Magnetic Generator:
Figure: 4.-G, + G, changes in platform weight compared to rpm
Figure: 1. Variant of one-row converter execution.
Figure: 2. A method of organizing the magnetic engagement of the stator and rollers.
Figure: 3. General diagram of a single-row magneto-gravity converter.
Figure: 4. Modes of operation of the magnetic-gravity converter.
Figure: 6. Scheme of corona discharge around a working converter /
Figure: 7. The location of the converter in the laboratory room and the location of concentric magnetic walls.
Figure: 8. Dependence of the intensity of the magnetic field and temperature change on the speed of the converter rotor.
In the footsteps of John Searl! Magnetic installation Roshchina, Godin: